Photovoltaic powered uninterruptible power supply using microcontroller PIC16F628-I/P

M. Irwanto; M. Farreq; S. P. Hadi; N. Gomesh; Y. M. Irwan

doi:10.4028/www.scientific.net/KEM.594-595.914

Photovoltaic powered uninterruptible power supply using microcontroller PIC16F628-I/P

M. Irwanto
, M. Farreq
, S. P. Hadi
, N. Gomesh
, Y. M. Irwan

Universiti Malaysia Perlis
Gadjah Mada University
Centre of Excellence for Renewable Energy (CERE) School of Electrical Systems Engineering

Research output: Chapter in Book or Report/Conference proceeding › Conference Proceeding › peer-review

Abstract

Uninterruptible power supply (UPS) sits between a power supply such as wall outlet and devices to prevent undesired feature that can occur within the power source such as outages, sags, surges and bad harmonics from the supply to avoid a negative impact on the devices. This paper presents a photovoltaic (PV) powered UPS using microcontroller PIC16F628A-I/P. It is a standby UPS whereas if the main power source fails to supply power to loads, a battery powered inverter turns on to continue supplying power. The battery is charged by the PV using solar charger and transfer switch controlled by the microcontroller. The UPS was tested to a load of 240 V, 20 W AC aquarium water pump. The test result shows that the UPS perform well, when the main power source fails, the battery could power inverter and the microcontroller controls the transfer switch of the UPS inverter and the main power source.

Original language	English
Title of host publication	Advanced Materials Engineering and Technology II
Publisher	Trans Tech Publications Ltd
Pages	914-918
Number of pages	5
ISBN (Print)	9783037859377
DOIs	https://doi.org/10.4028/www.scientific.net/KEM.594-595.914
Publication status	Published - 2014
Externally published	Yes
Event	2013 International Conference on Advanced Materials Engineering and Technology, ICAMET 2013 - Bandung, Indonesia Duration: 28 Nov 2013 → 29 Nov 2013

Publication series

Name	Key Engineering Materials
Volume	594-595
ISSN (Print)	1013-9826
ISSN (Electronic)	1662-9795

Conference

Conference	2013 International Conference on Advanced Materials Engineering and Technology, ICAMET 2013
Country/Territory	Indonesia
City	Bandung
Period	28/11/13 → 29/11/13

UN SDGs

This output contributes to the following UN Sustainable Development Goals (SDGs)

SDG 7 Affordable and Clean Energy

Keywords

Microcontroller
Photovoltaic
Uninterruptible power supply

Access to Document

10.4028/www.scientific.net/KEM.594-595.914

Cite this

@inproceedings{d23b5ae8d87143a1999677f689ebca87,

title = "Photovoltaic powered uninterruptible power supply using microcontroller PIC16F628-I/P",

abstract = "Uninterruptible power supply (UPS) sits between a power supply such as wall outlet and devices to prevent undesired feature that can occur within the power source such as outages, sags, surges and bad harmonics from the supply to avoid a negative impact on the devices. This paper presents a photovoltaic (PV) powered UPS using microcontroller PIC16F628A-I/P. It is a standby UPS whereas if the main power source fails to supply power to loads, a battery powered inverter turns on to continue supplying power. The battery is charged by the PV using solar charger and transfer switch controlled by the microcontroller. The UPS was tested to a load of 240 V, 20 W AC aquarium water pump. The test result shows that the UPS perform well, when the main power source fails, the battery could power inverter and the microcontroller controls the transfer switch of the UPS inverter and the main power source.",

keywords = "Microcontroller, Photovoltaic, Uninterruptible power supply",

author = "M. Irwanto and M. Farreq and Hadi, \{S. P.\} and N. Gomesh and Irwan, \{Y. M.\}",

year = "2014",

doi = "10.4028/www.scientific.net/KEM.594-595.914",

language = "English",

isbn = "9783037859377",

series = "Key Engineering Materials",

publisher = "Trans Tech Publications Ltd",

pages = "914--918",

booktitle = "Advanced Materials Engineering and Technology II",

note = "2013 International Conference on Advanced Materials Engineering and Technology, ICAMET 2013 ; Conference date: 28-11-2013 Through 29-11-2013",

}

Irwanto, M, Farreq, M, Hadi, SP, Gomesh, N & Irwan, YM 2014, Photovoltaic powered uninterruptible power supply using microcontroller PIC16F628-I/P. in Advanced Materials Engineering and Technology II. Key Engineering Materials, vol. 594-595, Trans Tech Publications Ltd, pp. 914-918, 2013 International Conference on Advanced Materials Engineering and Technology, ICAMET 2013, Bandung, Indonesia, 28/11/13. https://doi.org/10.4028/www.scientific.net/KEM.594-595.914

Photovoltaic powered uninterruptible power supply using microcontroller PIC16F628-I/P. / Irwanto, M.; Farreq, M.; Hadi, S. P. et al.
Advanced Materials Engineering and Technology II. Trans Tech Publications Ltd, 2014. p. 914-918 (Key Engineering Materials; Vol. 594-595).

Research output: Chapter in Book or Report/Conference proceeding › Conference Proceeding › peer-review

TY - GEN

T1 - Photovoltaic powered uninterruptible power supply using microcontroller PIC16F628-I/P

AU - Irwanto, M.

AU - Farreq, M.

AU - Hadi, S. P.

AU - Gomesh, N.

AU - Irwan, Y. M.

PY - 2014

Y1 - 2014

N2 - Uninterruptible power supply (UPS) sits between a power supply such as wall outlet and devices to prevent undesired feature that can occur within the power source such as outages, sags, surges and bad harmonics from the supply to avoid a negative impact on the devices. This paper presents a photovoltaic (PV) powered UPS using microcontroller PIC16F628A-I/P. It is a standby UPS whereas if the main power source fails to supply power to loads, a battery powered inverter turns on to continue supplying power. The battery is charged by the PV using solar charger and transfer switch controlled by the microcontroller. The UPS was tested to a load of 240 V, 20 W AC aquarium water pump. The test result shows that the UPS perform well, when the main power source fails, the battery could power inverter and the microcontroller controls the transfer switch of the UPS inverter and the main power source.

AB - Uninterruptible power supply (UPS) sits between a power supply such as wall outlet and devices to prevent undesired feature that can occur within the power source such as outages, sags, surges and bad harmonics from the supply to avoid a negative impact on the devices. This paper presents a photovoltaic (PV) powered UPS using microcontroller PIC16F628A-I/P. It is a standby UPS whereas if the main power source fails to supply power to loads, a battery powered inverter turns on to continue supplying power. The battery is charged by the PV using solar charger and transfer switch controlled by the microcontroller. The UPS was tested to a load of 240 V, 20 W AC aquarium water pump. The test result shows that the UPS perform well, when the main power source fails, the battery could power inverter and the microcontroller controls the transfer switch of the UPS inverter and the main power source.

KW - Microcontroller

KW - Photovoltaic

KW - Uninterruptible power supply

UR - https://www.scopus.com/pages/publications/84891841336

U2 - 10.4028/www.scientific.net/KEM.594-595.914

DO - 10.4028/www.scientific.net/KEM.594-595.914

M3 - Conference Proceeding

AN - SCOPUS:84891841336

SN - 9783037859377

T3 - Key Engineering Materials

SP - 914

EP - 918

BT - Advanced Materials Engineering and Technology II

PB - Trans Tech Publications Ltd

T2 - 2013 International Conference on Advanced Materials Engineering and Technology, ICAMET 2013

Y2 - 28 November 2013 through 29 November 2013

ER -

Photovoltaic powered uninterruptible power supply using microcontroller PIC16F628-I/P

Abstract

Publication series

Conference

UN SDGs

Keywords

Access to Document

Other files and links

Fingerprint

Cite this